E6C2-CWZ3E 1200P/R
se it for such purposes.
Do not use the Encoder under ambient conditions that exceed the
ratings.
● Wiring
Cable Extension Characteristics
•When the cable length is extended, the output waveform startup
time is lengthened and it affects the phase difference
characteristics of phases A and B. Conditions will change
according to frequency, noise, and other factors. As a guideline,
use a cable length of 10 m* or less. If the cable must be more than
2 m, use a Model with a Line-driver Output (max. length for linedriver output: 100 m).
* Recommended Cable
Conductor cross section: 0.2 mm2
Spiral shield
Conductor resistance: 92 Ω/km max. (20°C)
Insulation resistance: 5 Ω/km min. (20°C)
• The output waveform startup time changes not only according to
the length of the cable, but also according to the load resistance
and the cable type.
• Extending the cable length not only changes the startup time, but
also increases the output residual voltage.
●
0.4V以下
(负载电流35mA时)
施加电压:DC30V以下
源电流:35mA以下
残留电压:0.4V以下
(源电流35mA时)
输出电阻:2kΩ
输出电流:20mA以下
残留电压:0.4V以下
(负载电流20mA时)
AM26LS31相当品
输出电流 H等级:
IO = -20mA
L等级:
IS = 20mA
输出电压 VO = 2.5V以上
VS = 0.5V以下
响应频率 *3
100kHz
E6H-CW6C 600P/R 使用时的注意事项 选用及使用本公司产品时请理解如下要点。 (1) 除了额定值、性能指标外,使用时还必须遵守“使用条件等”。 (2) 客户必须自己负责确认“适用性等”,然后判断是否选用“本公司产品”。“本公司”对“适用性等”不做任何保证。 (3) 对于“本公司产品”在客户的整个系统中的设计用途,必须由客户自己负责对是否已进行了适当配电、安装等进行事先确认。 (4) 使用“本公司产品”时,客户必须采取如下措施:(i)相对额定值及性能指标,必须在留有余量的前提下使用“本公司产品”,并采用冗余设计等安全设计(ii)所采用的安全 设计必须确保即使“本公司产品”发生故障时也可将“客户用途”中的危险降到最小程度、(iii)构建随时提示使用者危险的完整安全体系、(iv)针对“本公司产品”及“客户 用途”定期实施各项维护保养。 (5) “本公司产品”是作为用于一般工业产品的通用产品而设计生产的。因此,不是为如下用途而设计生产的 atings. ● Mounting • The diameter of the mating shaft must be 8 mm and 8 to 11 mm long from the mounting surface. • The allowable displacement ...
E6H-CWZ6C 1000P/R 允许转速 10,000r/min 环境温度范围 工作时:-10~+70℃ (90%RH以下) 保存时:-30~+85℃ (不结冰) 环境湿度范围 工作时、保存时:各90%RH以下(不结露) 绝缘电阻 电容器接地的除外 耐电压 电容器接地的除外 C规格 IP50 连接方式 导线引出式(标准导线长 500mm) 材质 外壳 铁 本体 ...