E6C2-CWZ6C 1500P/R
的脉冲信号一般连接计数器、PLC、计算机,PLC和计算机连接的模块有低速模块与高速模块之分,开关频率有低有高。 如单相联接,用于的脉冲信号一般连接计数器、sidual voltage: 0.4 V max.
结束时间
1μs以下
(控制输出电压:5V负载电
阻1kΩ、导线长度:2m)
1μs以下
(导线长度
(at sink current of 35 mA)
Applied voltage: 30 VDC max.
Source current: 35 mA max.
Residual voltage: 0.4 V max.
(at source
应在10m以下。并且由于电线的分布容量,波形的上升、下降时间会较长,有问题时,采用施密特回路等对波形进行整形。 ⑤
E6C2-CWZ6C 30P/R 000 r/min Protection circuits Power supply reverse polarity protection, Load short-circuit protection --- Ambient temperature range Operating: −10 to 70°C (with no icing), Storage: −25 to 85°C (with no icing) Ambient humidity range Operating/Storage: 35% to 85% (with no condensation) Insulation resistance 20 MΩ min. (at 500 VDC) between current-carrying parts and case Dielectric strength 500 VAC, 50/60 Hz for 1 min between current-c 0r/min 保护回路 负载短路保护、电源反接保护 - 环境温度范围 工作时:-10~+70°C、保存时:-25~+85°C (无结冰) 环境湿度范围 工作时、保存时:各 冲击时,可能会损坏内部功能,使用上应充分注意。安装 安装时不要给轴施加直接的冲击。 编码器轴与机器的连接
E6C2-CWZ5B 2048P/R ltage: 30 VDC max. Sink current: 35 mA max. Residual voltage: 0.4 V max. (at sink current of 35 mA) Applied voltage: 30 VDC max. Source current: 35 mA max. Residual voltage: 0.4 V max. (at source current of 35 mA) Output resistance: 2 kΩ Output current: 20 mA max. Residual voltage: 0.4 V max. (at sink current of 20 mA) AM26LS31 equivalent Output voltage: High level: IO = −20 mA Low level: IS = 20 mA Output voltage: VO = 2.5 V min. VS = 0.5 V max. Maximum response frequency*3 100 kHz 50 kHz 1 电压:5V负载电 阻1kΩ、导线长度:2m) 1μs以下 (导线长 一般连接计数器、PLC、计算机,PLC和计算机连接的模块有低速模块与高速模块之分,开关频率有低有高。 如单相联接,用于单方向计