BURKERT传感器

德国宝德压力传感器，BURKERT传感器，宝德传感器
环境温度温度限制可能取决于传感器。请
请参考相应的指导手册或数据表
真正的工会，套管和外螺纹
流量变送器
?通用接头插入传感器，变送器，
在纯粹的，攻击性或contamined液体批量控制器
?大范围过程连接： DN 06 ?400
在聚氯乙烯，聚丙烯，聚偏氟乙烯，聚乙烯，不锈钢，黄铜
?可用于电子
- 指示，监控，传输
- 开/关控制，批量控制
媒体中的数据
流体温度
（ 160 °C。 ）
温度限制可能取决于传感器。请
请参考相应的指导手册或数据表
压力限制可能取决于传感器。请参阅
适当的使用说明书或数据表的更多
1 ）拟合和传感器之间的组合，有时仅限于一些DN （参见图： S020结合
下页上的传感器）Minimum straight upstream and downstream distances must be observed. According to the pipe’s design, necessary distances can be bigger or use a
flow conditioner to obtain the best accuracy. For more information, please refer to EN ISO 5167-1.
EN ISO 5167-1 prescribes the straight inlet and outlet distances that must be complied with when installing fittings in pipe lines in order to achieve
calm flow conditions. The most important layouts that could lead to turbulence in the flow are shown below, together with the associated prescribed
minimum inlet and outlet distances. These ensure calm, problem-free measurement conditions at the measurement point.
The flow rate sensor can be installed in either horizontal or vertical pipes.
Analysis measurement:
condition and enable the customer to calibrate the
unit without stopping the whole process or to use the special designed measuring chamber.
The specially designed measuring chamber enables to install all pH-, ORP-, conductivitytransmitters
or electrodes in all pipe systems, either directly in the main stream or in a
by-pass line. Additionally it enables to keep the electrode always wet and isolates it easily
from the main stream for calibration purposes.
Pressure and temperature ratings must be respected according to the selected fitting material.
The suitable pipe size is selected using the diagram Flow / Velocity / DN.