SMC精确气动滑台

进口SMC精确气动滑台，日本SMC气动滑台
Element replacement procedure
1. Stop operation and reduce the filter's internal
pressure to atmosphere.
2. Rotate the cover counterclockwise (“O” on the
cover ? L marking). Refer to Figure 1.
3. Pull the cover out of the case to remove the
element. Remove dust and other debris remaining
inside the case by blowing it out with
air, etc. (Also, confirm that the O-ring is not
4. Install a new element on cover and insert it into the case. Refer to Figure 2 and 3.
5. Adjust the protrusion on the cover and the slit on the case so that they match up, then push
the cover into the end of the case. Next, confirm that the cover is locked by attempting to rotate
it clockwise (“O” on the cover ? L marking).
6. Restart operation.
[Figure: ZFC05. The procedures for the ZFC10, 20 are alike.]
Related Products/Tubing: Nylon, Soft Nylon, Polyurethane
Use the kind of tubing indicated at the right for suction
filter with one-touch fitting (Series ZFC).
Refer to “Best Pneumatics No. 6” for
How to Order Tubing
T 0604 B 201. Connect tubing to the IN and OUT one-touch fittings in accordance
with the precautions for one-touch fittings.
1. When the element becomes clogged, stop operation and adjust
the internal pressure of the filter to atmospheric pressure
before replacing the element.
1. As a rule, replace the element when the pressure drops by
2. During disassembly and assembly, confirm that there are
scratches or damage, etc, on the O-ring.
3. Before using, confirm there is no leakage after replacing elements.
Operating Environment
1. Do not use tubings in atmospheres of corrosive gases, chemicals,
salt water, water steam, or where there is direct contact
with any of these.
Warning
1. Connect the piping in accordance with the flow direction
marked on the case. Proper sealing of the element cannot
guaranteed if connections are reversed.

进口SMC精确气动滑台，日本SMC气动滑台