G81501旋转式传感器 通用型传感器 高转速测试仪

旋转式传感器通用型传感器高转速测试仪

Rotary sensors high precision speed universal tester

型号:G81501

Model: G81501

产品简介：

Product synopsis:

　旋转式传感器：

Rotary sensors:

　本传感器为通用型传感器，适合于动力设备与负载之间有的距离，同时动力设备、负载是一个相对体的旋转动力系统，需用联轴器将传感器安装于动力设备与负载之间。

This sensor is a general-purpose sensor, suitable for power equipment and load, there is enough distance between power equipment at the same time, the load is a relatively independent body all the rotating power system, will need coupling sensor installed between the power equipment and the load.

转速测量分为：

Speed measurement is divided into:

1、高转速测量时采用光电、码盘原理设计 。

1, high speed measurement on the principle of photoelectric and encoder design.

2、测量角度、位移及低转速时采用增量式编码器原理设计，测量转速高，性能稳定，使用寿命长。

2, measuring Angle and displacement and the low speed on the principle of incremental encoder design to measure speed of high precision, stable and reliable performance, long service life.

产品特点：

Product features:

1、可测量稳态旋转扭矩及动态过渡过程的旋转扭矩。

1, measurable steady rotating torque and dynamic transition process of the rotary torque.

2、测量正、反向扭矩时，不需调整点。

2, measuring, positive and reverse torque does not need to adjust the zero point.

3、信号检测采用数字化处理技术，高、稳定性好、干扰强。

3, signal detection using dial processing technology, high precision, good stability, strong anti-jamming.

4、输入电源性、幅值保护，输出转矩、转速信号保护。

4, the input power supply polarity and amplitude protection, output torque and rotational speed signal protection.

5、扭矩信号的提取方式为应变电测技术。

5, torque signal extraction method for strain electrical measuring technology.

6、扭矩测量与旋转速度、方向无关。

6, torque measurement precision has nothing to do with the rotating speed and direction.

7、可测量正反向扭矩、转速及功率。

7, measurable positive and negative torque, rotational speed and power.

8、输入、输出信号的传输为非接触的耦合方式。

8, input, output signal tranission for non-contact coupling mode.

9、体积小、重量轻、安装方便。

9, all volume, light weight, convenient installation.

10、性高、寿命长。

10, high reliability, long service life.

技术参数：

Technical parameters:

转矩准确度：≤0.2% F·S

Torque accuracy: 0.2% or less f. S

过载能力：　150%F·S

Overload capacity: 150% f. S

缘电阻：　≥200MΩ

Insulation resistance: 200 m Ω or higher

工作温度：　-20～60℃

Working temperature: - 20 ~ 60 ℃

重复性：　　≤0.1%F·S

Repeatability: 0.1% or less f. S

滞 后：　　 ≤0.1%F·S

After the delay: 0.1% or less f. S

线 性：　　 ≤0.1%F·S

Sex: 0.1% or less f. S

相对湿度：　≤90%RH

Relative humidity: 90% RH or less

应变计动态应变波的响应时间：3.2×10-6S

Strain gauge of dynamic strain wave response time: 3.2 x 10-6 s

转矩频率输出：10KHz

Zero frequency output torque: 10 KHZ

正向转矩满量程频率输出：15KHz

Positive full range frequency output torque: 15 KHZ

反向转矩满量程频率输出：5 KHz

Reverse torque full range frequency output: 5 KHz

转速输出信号（光电码盘式）：60-120个脉冲/转 标准配置

Speed output signal (light code disc) : 60-120 pulses/standard configuration

转速输出信号（旋转编码器式）： 900-2000个脉冲/转 选配

Speed output signal (rotary encoder) : 900-2000 pulses/roll matching

传感器信号输出：方波信号、幅值为5V、负载电流＜15mA

Sensor signal output: the square wave signal, amplitude of 5 v, load current < 15 ma

传感器功耗：4W

The power consumption of the sensor: 4 w