Featur:
·AC/DC high frequence power supply
·Input voltage range 90-264VAC, output voltage 5V Single Output
·Proteions:Short circuit/Overload/Over voltage/Over temperature
·Built-in aive PFC funion
·2 years warranty
SPECIFICATION
MODEL | 200WF-05SA | ||
OUTPUT | DC VOLTAGE | 5V | |
RATED CURRENT | 40A | ||
CURRENT RANGE | 0-40A | ||
RATED POWER | 200W | ||
RIPPLE&ISE | 70mVp-p | ||
VOLTAGE ADJ.RANGE | 4.9-5.1V | ||
VOLTAGE TOLERANCE | &plun;1% | ||
LINE REGULATION | &plun;0.5% | ||
LOAD REGULATION | &plun;1% | ||
HOLD UP TIME(T) | 50ms/230VAC at full load | ||
INPUT | VOLTAGE RANGE | 90-264VAC | |
FREQUENCY RANGE | 47-63Hz | ||
EFFICIENCY (T) | >85% /230VAC >80%/115VAC at full load | ||
POWER FAOR (T) | PF>0.95 at full load | ||
AC CURRENT | 115VAC | 2Aat full load | |
230VAC | 1Aat full load | ||
INRUSH CURRENT (T) | <36A/230VAC <15A/115VAC at full load | ||
LEAKGE CURRENT | <0.5mA | ||
PROTEION | OVERLOAD | 115-130% rate output power | |
Proteion te:Constant current limiting,recovers automatically after fault conditiond is removed | |||
OVER VOLTAGE | 5.5V | ||
Proteion te:Shut down o/p voltage,re-power on to recover | |||
OVER TEMPERATURE | 80℃&plun;5℃ | ||
Protion te: Shut down 0/p voltage recovers automatically after temperature go down | |||
ENVIRONMENT | WORKING TEMP | –20～+60℃ | |
WORKING HUMIDITY | 5～95% RH | ||
STORAGE TEMP.,HUMIDITY | –40～+85℃.5～95% RH | ||
TEMP.COEFFICIENT | &plun;0.05% (0～50℃) | ||
VIBRATION | 10～100Hz 2G 10min./1cycle,60min.each alongX,Y,Zax | ||
SAFETY
| WITHSTAND VOLTAGE | I/P-O/P:3KVAC,5mA I/P-FG:1.5KVAC,5mA, O/P-FG:0.5KVAC,5mA
| |
ISOLATION RISTANCE | ≥100M | ||
OTHERS | MTBF | 50000hours | |
DIMENSION | 220*60*26mm(L*W*H) | ||
PACKING |
| ||
TE | 1.All parameters T specially mentioned are measured at 230VAC input,rated load and 25℃of ambient temperature. | ||
2.Ripple&ise are measured at 20MHZ of bandwidth by using a 12"twisted pair-wire terminated with a 0.1uf&47uf parallel capacitor. | |||
3.Tolerance:includ set up tolerance,line regulation and load regulation. | |||
4.The power supply is considered a component which will be installed into a final equipment.The final equipment must be re-confirmed that it still meets EMC direiv. | |||
5.Derating may be needed under low input voltag,Please check th derating curve for more details. | |||
