1. SCOPE
This specification dcrib the performance charaeristics of a grounded,12Watts, Single Output Switching Adapter. In addition, it defin a worldwide safety requirement and eleromagnetic compatibility requirement for Switching Adapter.
2. INPUT REQUIREMENTS
SN | Item | Specifications | Remark |
2.1 | Input voltage | AC100~240V | AC 90~264VAC MAX |
2.2 | Input Frequency | 50/60Hz | 47-63HZ MAX |
2.3 | Input Current | 0.3AMAX |
|
2.4 | Non-load loss | <0.5W |
|
3. OUTPUT SPECIFICATION
SN | Item | Specifications | Remark |
3.1 | Output voltage | 12.0V+/-5% | Output current from 0A to1.0 A |
3.2 | Output current | DC0~1.0A |
|
3.3 | Ripple | ≤300mVp-p | Load is1.0A,CR mode, parallel with a10uF/50V and a 0.1uF capacitor |
3.4 | Remain time | ≥10ms | AC 230V INPUT. |
4. ENVIRONMENT
SN | Item | Specification | Remark |
4.1 | Operating ambient temperature range | 0℃~40℃
| -10℃~45℃No damage and No funion error |
4.2 | Operating ambient humidity range | 20%~90%RH |
|
4.3 | Storage temperature | -20℃~85℃ |
|
4.4 | Storage humidity | 20%~90%RH |
|
4.5 | Atmospheric prsure. | 76~106Kpa |
|
5.PROTEION
Input Over Current proteion
A1Afusein the input circuit loop, if any input over current occurs,The fuse will opened. The power supply will work after a new fuse being installed.
Output Over Voltage Proteion
If any over voltage occurs, the power supply should latch off. The power supply will be automatically recovered after the over voltage fault being removed.
Output Current Proteion
If any over current occurs, the power supply should latch off before any output exceeds its limit below:
Nominal Current | Over Current Range |
1000mA+/100mA | 0.9-1.5A |
The power supply will be automatically recovered after the over voltage fault being removed.
Output Short Circuit Proteion
Short circuit occurred on +12V output should not cause any damage to the power supply but shut down the power supply. The power supply will be automatically recovered.
Over Load Proteion
An over proteion will be effeed when overloading reach 100%-150% Max. load. The power supply will be automatically recovered.
6. EFFICIENCY/RISE TEMPERATURE
6.1 Efficiency
The efficiency is70% when this power supply is working under tical station.
6.2Casetemperaturerise
Casetemperaturerise is ls than40℃when this power supply works in 25℃ambient temperature.
7. SAFETY REQUIREMENT
7.1 Insulation withstand voltage
There shall be no abnormality when 3000VAC(sensing current 5mA) is imprsed across AC conneor and DC terminal for one minute.
7.2 Insulation ristance
Shall be 100MΩ or more, measure with 500VDC conneed between input conneor and DC terminal.
7.3 Leakage current:≤0.25mA, 230VAC, full load
8. BURN-IN TT
100% burn-in tted at Max. load under 40+/-5 degree centigrade.
9. WEIGHT: this power supply is about 80g