台湾微处理多功能4位双显示 MDW 功率表:
●简介:MDW-20功率表是以微处理器为基础,可测量单相电力系统参数,电脑化校正,具RS-485/RS-232界面输出的多功能电力表。使用者可经由RS-485/RS-232读取或设定参数.
●规格: 准确度(在23&plun;5℃环境)
V:&plun;0.1% of Reading&plun;0.15% of Range (量测范围10%~110% of Range )
A:&plun;0.1% of Reading&plun;0.15% of Range (量测范围10%~110% of Range )
W:&plun;0.2% of Reading&plun;0.3% of Range
VAR:&plun;0.2% of Reading&plun;0.3% of Range
PF:&plun;0.2% of Reading&plun;0.3% of Range
PF Polarity:—=leading
+=lagging
WHr:&plun;0.4% of Reading
VARHr:&plun;0.4% of Reading Hz:&plun;0.2% of Reading
范围:V:10~100% A:5~100%
PF:0.5~&plun;1.0 Hz:50Hz
信号频率:49~70Hz
、PT倍比设定:1~999.9
工作温度:-10~+50℃
●PT、倍比设定:
设定比压器(PT)或()之倍比,使量测值能反应负载之实际电压、电流。
●可设定两段继电器报警输出及设定继电器输出间。
◆特点 FEATUR:
●4位双显示功率/电压/电流/功率因数/频率。
●具有电流/电压/功率因数/频率可切换功能。
●电压、电流测量均为值(TRMS)。
●宽幅设定、PT倍数:1~999.9。
●通讯功能:通讯格式合标准 Modbus Protocol(RTU mode)。通讯接口为 RS-485/RS-232连接方式,通讯地址和波特率(2400、4800、9600、19200)均可设定。的测量数据都可以经由串列埠读出。
●系数参数均存放在 EEPROM(掉电记忆)中,不需要电池既可长存。
●采用ABS火外壳(94-vo)。
●规格和量程范围可订制。
●DIN 外壳96*48mm
◆技术参数 Specifications:
显示 Display | 上:红色LED 0.4”high(Watt) 下:绿色LED 0.3”high(V,A,PF,Hz) |
显示 Max. Display | 四位数9999(Watt),四位数9999(V,A,PF,Hz) |
性显示 Polarity Display | “-”号自动显示 symbol is displayed automatically |
量程显示 Over range Indication | “o. L” |
采样速度 Conversion Rate | 2.5次/秒(DC)或1次/秒(AC) |
小数点 Decimal Point | 用按钮任意设定Settable to any di position by front sheet switch |
输出界面 Output | RS-485或RS-232(MOdbus) |
Accuracy | AC&plun;0.3%FS.&plun;2 di,DC&plun;0.2%FS.&plun;2 di |
工作环境温、湿度 Operating Temp. | 0~50℃/小于(Below)80%R.H. (无冷凝No Condensation) |
贮存环境温、湿度 Storage Temp. | -10~60℃/小于70%R.H. (无冷凝No Condensation) |
使用电源 Power Supply | AC100~240V&plun;10%,50/60Hz订制 DC12,24,48,120&plun;20% |
电源消耗 Power Consumption | 约5VA |
重量 Weight | 约550克 |
耐压强度 Dieleric Strength | AC 1500V/1min(输入/电源Input/Power) |
缘阻 Insulation Ristance | 500VDC时,大于100MΩ |
外形尺寸 Dimensions | 96(W)&tim;48(H)&tim;144(D)mm |
安装尺寸 Panel Cut-out | 91.5(W)&tim;44(H) mm |
输入范围 AC0~600V,0~10A(可订制) DCAC0~600V,0~10A(可订制)
外形尺寸图Dimensions
以上资料供参考,请以实物为准。下面为我公司其他仪表图片: