Fireye价格优惠！ Fireye红外扫描仪，fireye 70D41控制器, Fireye control价格优惠！原装美国火焰检测器，Fireye紫外线扫描仪，Fireye Relay, Fireye module, Fireye紫外传感器，fireye价格，85UVF1-1QD价格，Fireye紫外传感器，Fireye火警报警仪, Fireeye 紫外，Fireeye火焰..Fireeye 燃烧控制器
---------------
Fireye 70D41, For manually ignited burners, 230 VAC Burner Management Controls provide ignition and flame failure protection for manually started oil or gas
产品介绍：
70D40 Control and Cover
72D1R1 Plug-in amplifier
48PT2 Flame Scanner (specify cable length and mount)
60-1386-2 Wiring Base
Fireye D40-41 controls supersede similar Fireye C-Seri controls and are directly plug-in replaceable.
The following chart illustrat the comparison.
Control 70D40 with Amplifier 72DUV1 will also replace a Fireye Te 25DU4 model 5040 provided
the wiring is changed to the appropriate wiring shown later in this document.
te: When a C-Seri unit is replaced with a D-Seri unit, the chis retaining clip (for a quarter
turn fastener) in the wiring base must be replaced with a threaded clip that is supplied with each DSeri
Control.
A. Code 1 terminal load ratings all models: B. Terminal Load ratings for 70D40 Code 2 Models:
Max. Rating of each external load terminal: TERMINAL MAXIMUM RATINGS
125 VA PILOT DUTY TERMINAL 7 ONLY: Alternate
Rating — 300 VA transformer
and 130 VA pilot duty; and maximum
coined load of t more
than 3 motorized valv —
Holding — 180 VA
Opening— 635 VA
Locked Rotor — 730 VA
3, 5, 6, 8, X, A
120 VAC 230 VAC 7
Code 2
or higher
models only
250 VA Pilot Duty or Motor rating as given below:
5 amps 2.5 amps Voltage 120 VAC 230 VAC
125 VA
Pilot Duty
125 VA
Pilot Duty
FULL LOAD 9.8 A 5.1 A
LOCKED ROTOR 58.8 30.6 A
C. CE Load ratings for 70D41
TERMINAL MAXIMUM RATING AT 253 VAC
3, 5, 6, 8, 13, D 1A RISTIVE OR (cos ? = 1)
7, A, M, P, X 4.5A RISTIVE OR (cos ? = 1)
D SERI C SERI
OBSOLETE PART NUER COMPONENTS
D40-5030 Control 70D40 - Amplifier 72D1R1 Te 26DF4 - Model 5030
D41-5131 Control 70D41 - Amplifier 72D1R1T Te 26DF4 - Model 5131
D40-5060 Control 70D40 - Amplifier 72DUV1 Te 25DU4 - Model 5060
D41-5161 Control 70D41 - Amplifier 72DUV1T Te 25DU4 - Model 5161
D40-5050 Control 70D40 - Amplifier 72DRT1 —
D41-5151 Control 70D41 - Amplifier 72DRT1T —
DCRIPTION OF FIREYE SERI D40-41 COMPONENTS
Control Chis and Cover Amplifier Flame Scanner
Use with
70D40 (120VAC) 50-60 Hz
or
70D41 (230VAC) 50/60 Hz
Rectification
72DRT1 2-4 sec. FFRT
72DRT1T 1 sec. FFRT
69ND1-1000K4
69ND1-1000K6
69ND1-1000K8
1/2" mount 12" (300mm) flame rod.
1/2" mount 18" (450mm) flame rod.
1/2" mount 24" (600mm) flame rod.
Infrared (IR) “Autocheck”
72D1R1 2-4 sec. FFRT
72D1R1T 1 sec. FFRT
*72D1R3 2-4 Sec. FFRT
*72D1R3T 1 Sec. FFRT
* For specific applications see te
below.
48PT2-1003
48PT2-9003
48PT2-1007
48PT2-9007
1/2 straight mount 96" (2400mm) cable.
1/2 angle mount 96" (2400mm) cable.
1/2" straight mount 48" (1200mm) cable.
1/2" angle mount 48" (1200mm) cable.
Ultraviolet (UV)
72DUV1 2-4 sec. FFRT
72DUV1T 1 sec. FFRT
UV8A
UV1A3
UV1A6
UV2
UV90-3, -6, -9
45UV3-1050
1/2" angle mount 72" (1800mm) wire ( cable).
1/2" straight mount 36" (900mm) cable.
1/2" straight mount 72" (1800mm) cable.
3/8" straight mount 36" (900mm) cable.
90º side opening, 36" (900mm), 72" (1800mm),
or 108" (2700mm) cable.
3/4" straight mount cast aluminum housing,
72" (1800mm) wire ( cable).
70D40 Only 72DUVS4 Repetitive Self-Check
2-4 sec. FFRT
72DUVS1T Repetitive Self-Check
1 sec. FFRT
45UV5-1009
or
45UV5-1008
1" NPT mount 72" (1800mm) wire ( cable),
120VAC shutter.
or
1" BSP mount 72" (1800mm) wire (
cable),120VAC shutter.
70D40M Only Infrared (IR) AUTOCHECK
72D1R3TM 1 sec. FFRT
For special applications see te
below.
48PT2-1003
48PT2-9003
48PT2-1007
48PT2-9007
1/2" straight mount 96" (2400mm) cable.
1/2" angle mount 96" (2400mm) cable.
1/2" straight mount 48" (1200mm) cable.
1/2" angle mount 48" (1200mm) cable.
70D41 Only 72DUVS1T or 72DUVS4 45UV5-1007 1" BSP mount 72" (1800mm) wire, cable.
230VAC shutter
Wiring Base 60-1386-2 Standard base for surface mounting
60-1466-2 Open base for cabinet mounting
TE: Infrared “AUTOCHECK” amplifier modul 72D1R3, 72D1R3T, and 72D1R3T may be used for burner applications firing special
fuel such as sawdust, sander dust, low BTU gas. The 72D1R3 te amplifiers are t to be used on any liquid fuel fired burner as it may
rult in malfunction causing damage to property and/or injury to personnel.
ACCSORI / SPARE PARTS
Part . Dcription Used with Part . Dcription Used with
4-263-1 Firetron Cell 48PT2 60-801 1/2" Coupling w/Pyrex Window 48PT2
4-314-1 UV Tube 45UV5, 45UV3 60-1199-1 1" NPT Coupling w/Quartz Window 45UV5-1009
10-88 Set of 3 orifice plugs 48PT2 60-1199-2 1" BSP Coupling w/Quartz Window 45UV5-1009
35-69 1/2" NPT Heat Insulator 48PT2-UV1 60-1257 1/2" Coupling w/Quartz Window UV1A
35-127-1 1" NPT Heat Insulator 45UV-1290 1/2" Coupling w/Quartz Lens UV1A
35-127-3 1" BSP Heat Insulator 45UV5-1007/8 60-1664-3 1" NPT Swivel Mounting Flange 45UV5-1009
46-38 Quartz Lens 45UV5 60-1664-4 1" BSP Swivel Mounting Flange 45UV5-1007/8
60-302 Swivel Mounting Flange 48PT2, UV1A 61-436 Lens Cap 48PT2
