1.7LED display.2.Measure range:0-2.0%(thickns of the salt) . 3.High accuracy:是+/-0.2% .4.Easy to control. 5.Use CU sensor.6. Push button 1)Object detector: aqueous solution (food/water, etc) ,Measuring range: 0 ~ 2.0%.Measuring accuracy: &plun; 0.15% (0.0 ~ 0.7%).Power input: 6V (4 &tim; 1.5V) LR44 &tim; 4. Applicable temperature: 20 ~ 80 centigrade.Dimensions: 27 x 3.4 x 2.0cm CE
Salt yzer Instructions
【Introduction】
Too much salt in human’s diet will easily lead hertension. Rearch show over10 grams of salt in human’s daily diet has higher chanc of causing hertension. Human body should aim at taking leas than 10 grams of salt daily. The salt yzer us conductivity tt to measure the salt concentration in liquid food. Thus, the salt content can be derived to control the daily intake of salt and maintain health. The equipment featur in touch pad control, seven red LED indicators, green LED power indicator, easy operation and simple use. It is good for your health care.
【Dcription ofParts】
① probe
② main unit
③ panel
④ indicator
⑤ push button
⑥ battery cover
【Dcription of Functions】
Please refer to the figure showing parts of the yzer for dcription of functions.
① probe：measure salt concentration
③ 7 red LED for indicating salt concentrations：
0.3%~ 0.6%(Moderate); 0.8%~1.0%(Thick);
1.3%~2.0%(Very Thick).
④ One green LED as power indicator.
⑤ ON push button：prs the button to power on, then it is ready for measurement.
【Dcription of Use】
n Check the cleanns of the probe. Useneutral detergentfor cleaning.
n Put the sample in a container with a certain liquid level.
n Prs power button ON. The green power light should be on. If not, it is low battery power and battery replacement is required.
n Put the probe under the liquid surface by at least 2 cm and keep a distance of at least 1-cm from the container wall. When the indicator light is stable, take the hight reading as the measured value.
n When the measurement is completed, use neutral detergent for cleaning the probe.
【Specifications】
Power requirement：4&tim;1.5=6V LR44&tim;4
Load current：MAX 20mA(all LED on)
Dimension： 212&tim;24.8&tim;15.4(mm)
Weight：approximately36grams
Range of Measurement： 0.3%～2.0%
Range of temperature apply : 60℃～80℃
Formula: Salt content =Total quality & quantity &tim; concentration
Example: Total quality & quantity of gl of solution is 150g and its concentration is 0.5%
150g&tim; 0.5% = 0.75g
【Not for Battery Change】
- Remove batter cover and
take out four used
batteri and dispose
them properly. Keep
out of reach of children
(as shown in Figure).
- Put fourV new alkaline batteriback to battery compartment (as shown in Figure).
【Maintenance】
Cleaning：
n Use clean water to rinse or cloth with neutral detergent to clean the probe.
n Do not use water or clothe with neutral detergent to clean the main unit.
n Do not use alcohols, diluents and gasoline to clean the probe and the main unit.
Storage：
n Avoid falling of shaking of the equipment. Otherwise, malfunction may occur.
n Keep out of heat, direct sunlight exposure and dampns.
n Remove batteri when the equipment is not used for a long time.
