HF-8811 电线加热变形试验机
PARALLEL PLATE PLASTOMETER
JIS-C-3005
试料本机温度中，加热 30 分钟后，夹在本机平行板间，加规定之荷重，于同温下再经 30 分钟，然后以加热前后之厚度差，除以加热前厚度，以百分比为单位，即为变形率。
This machine is used for the heat deformation test of power cords。Put specimen into test chamber of this machine under a certain temperature for 30 minutes，then clamp specimen between two parallel plates，the upper plates being subject to a constant load under the same temperature for 30 minutes。Afterwards，the differential thickness before / after heating is
divided by the thickness before heating and multiplied by % for being unit，that is deformation。
|
试料数量 Specimen volume |
3 组 ( sets ) |
|
温度控制器 Temp. controller |
PID 数位设定 PID dial setting |
|
温度范围 Temperature range |
室温 Room temp. ~ 200℃ |
|
砝码 Load |
50，100，200，500，1000g |
|
厚度计 Micro-gauge |
0.01 ~ 10mm |
|
电源 Power |
AC220V / 50Hz |
