E6C2-CWZ5B 20P/R
承负荷比规定荷重小,可大大延长轴承寿命。 不要将旋转编码器进行拆解,这样做将有损防油和防滴性能。防滴型产品不宜长期浸在水、油中,表面有水、油时应擦拭干净。 (2)振动 加在旋转编码器上的振动,往往会成
~500Hz 上下振幅 2mm或150m/s2 X、Y、Z各方向扫频11min/次 扫频3次
冲击(耐久)
1,000m/s2 X、Y、Z各方向 3次
保护结构
IEC标准 IP64、公司内部标准 防油
连接方式
导线引出型(标准导线长2m)
between outputs
90°±45° between A and B (1/4 T ± 1/8 T)
Rise and fall times of
output
1 μs max.
(Control output voltage: 5 V, Load
resistance: 1 kΩ, Cable length:
2 m)
1 μs max.
(Cable length: 2 m, Sink current: 10 mA)
0.1 μs max.
(Cable length: 2 m, IO = −20 mA,
IS = 20 mA)
Starting torque 10 mN·m max.
Moment of inertia 1×10
−6
kg·m2
max.; 3 × 10
−7
kg·m2
max. at 600 P/R
E6C2-CWZ3E 3000P/R 对称负信号输出的编码器,信号传输距离可达150米。 旋转编码器由精密器件构成,故当受到较大的冲击时,可能会损坏内部功能,使用上应充分注 引出型(标准导线长2m) 材质 外壳 锌合金 本体 铝 轴 SUS420J2 imum response frequency*3 100 kHz 50 kHz 100 kHz Phase difference between outputs 90°±45° between A and B (1/4 T ± 1/8 T) Rise and fall times of output (Control output voltage: 5 V, Load resistance: 1 kΩ, Cable length: 2 m) 1 μs max
E6C2-CWZ3E 3000P/R verse polarity protection, Load short-circuit protection --- Ambient temperature range Operating: −10 to 70°C (with no icing), Storage: −25 to 85°C (with no icing) Ambient humidity Operating/Storage: 35% to 85% (with no condensation) Insulation resistance 20 MΩ min. (at 500 VDC) between current-carrying parts and case Dielectric strength 500 VAC, 50/60 Hz for 1 min between current-carrying parts and case Vibration resistance Destruction: 10 to 500 Hz, 150 m/s 2 or 2-mm double amplitude for 11 min 3 times each in X, Y, and Z directions Shock resistance Destruction: 1,000 m/s 2 3 times each in X, Y, and Z directions 1 × 10-6kg·m2以下(600P/R以下为3 × 10-7kg·m2以下) 轴 负载 径向 50N 轴向 30N 允许转速 6,000r/min ...