E6H-CW6C 800P/R
1μσ以下 控制输出电压:5V 负载电阻:1kΩ 导线长度:
1μσ以下 I0=-10mA IS=10mA导线长度:
起动扭矩
惯性力矩
2×10-
轴允许力
径向
29.4N
the customer's request, OMRON will provide applicable third party certification documents identifying ratings and limitations of use that apply to the
products. This information by itself is not sufficient for a complete determination of the suitability of the products in combination with the end product,
machine, system, or other application or use.
The following are some examples of applications for which particular attention must be given. This is not intended to be an exhaustive list of all possible
u 2. 电的应答转速根据分辨率的响应频率规定
因此,旋转超过响应转速时,则电气上不能追纵信号。
* 3. 对水、油无法保护。
* 4. 所谓线性驱动输出bject to separate industry or government regulations.
Systems, machines, and equipment that could present a risk to life or property.
Please know and observe all prohibitions of use applicable to the products.
NEVER USE THE PRODUCTS FOR AN APPLICATION INVOLVING SERIOUS R
E6H-CWZ5G 2000P/R Disclaimers CHANGE IN SPECIFICATIONS Product specifications and accessories may be changed at any time based on improvements and other reasons. It is our practice to change model numbers when published ratings or features are changed, or when significant construction changes are made. However, some specifications of the products may be changed without any notice. When in doubt, special model numbers may be assigned to fix or establish key specifications for your application on your request. Please consult with your OMRON representative at any time to confirm actual specifications of purchased products. DIMENSIONS AND WEIGHTS Dimensions and weights are nominal and are not to be used for manufacturing purposes, even when tolerances are shown. PERFORMANCE DATA Performance data given in this catalog is provided as a guide for the user in determining suitability and does not constitute a warranty. It may represent the result of OMRON’s test condition...
E6H-CWZ3E 2500P/R 、下降时间 1μσ以下 控制输出电压:5V 负载电阻:1kΩ 导线长度:500mm 1μσ以下 I0=-10mA IS=10mA 导线长度:500mm 起动扭矩 1.5m·N以下 容器接地的除外 振动(耐久) 10~500Hz 100m/s2或者复振幅1.5mm X、Y、Z方向 各2h 冲击(耐久) 300m/s2 11ms X、Y、Z方向 各3次(除去对轴部的冲击) 保护结构 * 3 IEC规格 IP50 连接方式 导线引出式(标准导线长 500mm) 动(耐久) 10~500Hz 100m/s2或者复振幅1.5mm X、Y、Z方向 各2h 冲击(耐久) ...