E6C2-CWZ1XH 2500P/R
torage: 35% to 85% (with no condensation)
Insulation resistance 20 MΩ min. (at 500 VDC) between current-carrying parts and case
Dielectric strength 500 VAC, 50/60 Hz for 1 min between current-carrying parts and case
Vibration resistance Destruction: 10 to 500 Hz, 150 m/s
2
or 2-mm double amplitude for 11 min 3 times each in X, Y, and Z directions
Shock resistance Destruction: 1,000 m/s
2
3 ti
允许转速
6,000r/min
保护回路
负载短路保
DC5V - 5%~24V + 15%
纹波(p-p) 5%以下
DC12V - 10%~24V + 15%
纹波(p-p) 5%以下
DC5V - 5%~12V + 10%
纹波(p-p) 5%以下
DC5V ± 5%
纹波(p-p) 5%以下
消耗电流 *1
80mA以下
100mA以下
160mA以下
分辨率
(脉冲/旋转)
10、20、30、40、50、
60、100、200、300、
360、400、500、600、
720、800、1,000、
1,024、1,200、1,500、
1,800、2,000
E6C2-CWZ5B 1500P/R 耐电压 AC500V 50/60Hz 1min 导线端整体与外壳间 振动(耐久) 10~500Hz 上下振幅 2mm或150m/s2 X、Y、Z各方向扫频11min/次 扫频3次 冲击(耐久) 1,000m/s2 X、Y、Z各方向 3次 保护结构 IEC标准 IP64、公司内部标准 防油 连接方式 导线引出型(标准导线长2m) *1. An inrush current of approximately 9 A will flow for approximately 0.3 ms when the power is turned ON. *2. The line driver output is a data transmission circuit compatible with RS-422A and long-distance transmission is possible with a twisted-pair cable.(AM26LS31 equivalent) *3. The maximum electrical response speed is determined by the resolution and maximum response frequency as follows: This means that the E6C2-C Rotary Encoder will not operate electrically if its...
E6A2-CS3C 1000P/R信号输出有正弦波(电流或电压),方波(TTL、HTL),集电极开路(PNP、NPN),推拉式多种形式,其中TTL为长线差分驱动(对称A,A-;B,B-;Z,Z-),HTL也称推拉式、推挽式输出,编码器的信号接收设备接口应与编码器对应。A相、 B相 100、 200、 360 E6A2-CW3E (分辨率) 0.5M 500 例:E6A2-CW3E 100P/R 0.5M 集电极开路输出 (NPN输出) 100、 200、 360 E6A2-CW3C (分辨率) 0.5M 500 例:E6A2-CW3C 100P/R 0.5M DC12~24V 100、 200、 360 E6A2-CW5C (分辨率) 0.5M 500 例:E6A2-CW5C 100P/R 0.5M DC5~12V 电压输出 A相 10、 (20)*、 60、 100、 200、 300、 360 E6A2-CS3E (分辨率) 0.5M 500 例:E6A2-CS3E 10P/R 0.5M 集电极开路输出 (NPN输出) 10、 20、 60、 100、 200、 300、 360