E6C2-CWZ5G 360P/R
LIABILITY.
In no event shall the responsibility of OMRON for any act exceed the individual price of the product on which liability is asserted.
IN NO EVENT SHALL OMRON BE RESPONSIBLE FOR WARRANTY, REPAIR, OR OTHER CLAIMS REGARDING THE PRODUCTS UNLESS
OMRON'S ANALYSIS CONFIRMS THAT THE PRODUCTS WERE PROPERLY HANDLED, STORED, INSTALLED, AND MAINTAINED AND NOT
SUBJECT TO CONTAMINATION, ABUSE, MISUSE, OR INAPPROPRIATE MODIFICATION OR REPAIR.
Application Considerations
SUITABILITY FOR USE
OMRON shall not be responsible for conformity with any standards, codes, or regulations that apply to the combination of products in the customer's
application or use of the products.
At the customer's request, OMRON will provide applicable third party certification documents identifying ratings and limitations of use that apply to the
products. This information by itself is not sufficient for a complete determination of the suitability of the products in combination with the end product,
machine, system, or other application or use.
1 × 10-6kg·m2以下(600P/R以下为3 × 10-7kg·m2以下)
轴
负载
径向
50N
轴向
30N
允许转速
6,000r/min
保护回路
负载短路保护、电源反接保护
E6C2-CWZ5GH 400P/R 出电压:5V负载电 阻1kΩ、导线长度:2m) 1μs以下 (导线 动,往往会成为误脉冲发生的原因。因此,应对设置场所、安装场所加以注意。每转发生的脉冲数越多,旋转槽圆盘的槽孔间隔越窄,越易受到振动的影响。在低速旋转或停止时,加在轴或本体上的振动使旋转槽圆盘抖动,可能会发生ly 9 A will flow for approximately 0.3 ms when the power is turned ON. *2. The line driver output is a data transmission circuit compatible with RS-422A and long-distance transmission is possible with a twisted-pair cable.(AM26LS31 equivalent) *3. The maximum electrical response speed is deter
E6H-CW6C 120P/R 绝缘电阻 电容器接地,可除外 耐电压 电容器接地,可除外 振动 (耐久) 10~500Hz 100m/s 2或上下振幅1.5mm X、 Y、 Z方向 各2h 冲击 (耐久) 300m/s 2 11ms X、 Y、 Z方向 各3次 (不包括对轴部的冲击) 保护结构 *3 IEC标准 IP50 连接方式 导线引出型 (标准导线长500mm) 材质 外壳 铁 本体 铝 板簧 SUS304 质量 (包装后) 约120g 附件 使用说明书 DIMENSIONS AND WEIGHTS Dimensions and weights are nominal and are not to be used for manufacturing purposes, even when tolerances are shown. PERFORMANCE DATA Performance data given in this catalog is provided as a guide for the user in determining suitability and does not constitute a warranty. It may represent the result of OMRON’s test conditions, and the users must correlate it to actual application requirements. Actual performance is subject to the OMRON Warranty and Limitations of Liability. ERRORS AND OMISSIONS The information in this document has been carefully checked and