E6C2-CWZ1XH 1000P/R
能给轴加上比允许负荷还大的负荷,或造成拨芯现象,因此,要特别注意。 轴承寿命与使用条件有关,受轴承荷重的影响特别大。如轴承负荷比规定荷重小,可大大延长轴承寿命。 不要将旋转编码器进行拆解,这样做将有损oltage: 30 VDC max.
A相、B相的位相差90°±45° (1/4T±1/8T)
输出开始、
结束时间
1μs以下
(控制输出电压
Sink current: 35 mA max.
Residual voltage: 0.4 V max.
(at sink current of 35 mA)
Applied voltage: 30 VDC max.
Source current: 35 mA max.
Residual voltage: 0.4 V max.
(at source current of
E6C2-CWZ5GH 3000P 0r/min 保护回路 负载短路保护、电源反接保护 - 环境温度范围 工作时:- 力线并行配线,则有时会受到感应造成误动作成损坏,所以要分离开另行配线。 ④ 延长电线时,应在10m以下。并信号一般连接计数器、PLC、计算机,PLC和计算机连接的模块有低速模块与高速模块之分,开关频率有低有高。 current-carrying parts and case Dielectric strength 500 VAC, 50/60 Hz for 1 min between current-carrying parts and case Vibration resistance Destruction: 10 to 500 Hz, 150 m/s 2 or 2-mm d
E6C2-CWZ5G 2500P/R 荷比规定荷重小,可大大延长轴承寿命。 不要将旋转编码器进行拆解,这样做将有损防油和防滴性能。防滴型产品不宜长期浸在水、油中,表面有水、油时应擦拭干净。 (2)振动 加在旋转编码器上的振动,往往会成为误脉冲发生的原因。因此,应对设置场所、安装场所加以注意。每转发生的脉冲数越多,旋转槽圆盘的槽孔间隔越窄,越易受到振动的When the cable length is extended, the output waveform startup time is lengthened and it affects the phase difference characteristics of phases A and B. Conditions will change according to frequency, noise, and other factors. As a guideline, use a cable length of 10 m* or less. If the cable must be more than 2 m, use a Model with a Line-driver Output (ma 1,000m/s2 X、Y、Z各方向 3次 保护结构 IEC标准 IP64、公司内部标准 防油 连接方式 导线引出型(标准