E6C2-CWZ5G 1200P/R
Ω min. (at 500 VDC) between current-carrying parts and case
0r/min
保护回路
负载短路保护、电源反接保护
-
环境温度范围
工作时:-10~+70°C、保存时:-25~+85°C (无结冰)
环境湿度范围
工作时、保存时:各35~85%RH (无结露)
Dielectric strength 500 VAC, 50/60 Hz for 1 min between current-carrying parts and case
Vibration resistance Destruction: 10 to 500 Hz, 150 m/s
2
or 2-mm double amplitude for 11 min 3 times each in X, Y, and Z directions
Shock resistance Destruction: 1,000 m/s
2
3 times each in X, Y, and Z directions
Degree of protection IEC 60529 IP64, in-house standards: oilproof
Connection method Pre-wired Models (Standard cable length: 2 m)
可能会损坏内部功能,使用上应充分注意。安装 安装时不要给轴施加直接的冲击。 编码器轴与机器的连接,应使用柔性连接器。
E6C2-CWZ5G 3000P/R 100kHz 50kHz 100kHz 输出相位差 A相、B相的位相差90°±45° (1/4T±1/8T) 输出开始、 结束时间 1μs以下 (控制输出电压:5V负载电 阻1kΩ、导线长度:2m) 1μs以下 (导线长度:2m 负载电流:1 3 × 10 −7 kg·m2 max. at 600 P/R max. Shaft loading Radial 50 N Thrust 30 N Maximum permissible speed 6,000 r/min Protection circuits Power supply reverse polarity protection, Load short-circuit protection --- Ambient temperature range Operating: −10 to 70°C (with no icing), Storage: −25 to 85°C (with no icing) ① 配线应在电源OFF状态下进行,电源接通时,若输出线接触电源,则有时会损坏输出回路。 ② 若配线错误,则有时
E6C2-CWZ5G 1800P/R 30N 允许转速 6,000r/min 保护回路 负载短路保护、电源反接保护 - 环境温度范围 工作时:-10~+70°C、保存时:-25~+85°C (无结冰) 环境湿度范围 工作时、保存时:各35~8 pen-collector output PNP open-collector output Voltage output (NPN output) Line driver output*2 Output capacity Applied voltage: 30 VDC max. Sink current: 35 mA max. Residual voltage: 0.4 V max. (at sink current of 35 mA) Applied voltage: 30 VDC max. Source current: 35 mA max. Residual voltage: 0.4 V max. (at source current of 35 mA) Output resistance: 2 kΩ Output current: 20 mA max. Residual voltage: 0.4 V max. (at sink current of 20 mA) AM26LS31 equivalent Output voltage: High level: IO = −20 mA Low level: IS = 20 mA Output ...