本型电压互感器为全封闭产品。一次带有熔断器保护。熔断器装在互感器内部。一、二次绕组和铁芯均浇注在环氧树脂内,绝缘性能优良,耐潮湿。二次绕组中还带有110,220V输出电压端子供操作机构作电源。
The voltage transformers are fully enclosed products. The primaries of the products are protected
with fused. The fused is installed inside the transformer. Primary and secondary windings and iron core are insulated by epoxy resin. It has a good ability of insulation and moisture proof. The secondary winding offering the 110,220V voltage is used for power supply to operation machine.
四. 技术参数(Technical date)
1. 配用熔断器为XRNP□-12型,0.2A,50kA。(特殊要求请在订货时注明)(The fusible cutout’s type is XRNP□-12,0.2A,50kA (If special need, please notice when order ))
2. 局部放电水平符合GB1207-1997《电压互感器》标准。(The conditions of the partial discharge test are in accord with the standard GB1207-1997《Voltage transformer》with be fulfilled without exception.
3. 其他技术参数见表 (Other technical data see form)
本型电流互感器为单匝母线全封闭式,铁芯采用优质冷轧硅钢片卷绕而成。二次线圈沿圆周均匀地绕在铁芯上,无一次母线,亦不附有夹紧母线装置。 本型电流互感器用环氧树脂混合浇注成形,在浇注体上的标志P1是一次母线的起端,二次线圈的起端和终端分别标以S1和S2。 技术数据: 额定一次电流:50-630A; 额定二次电流:5A;额定负荷及准确级:15VA 5P10/3; 额定绝缘水平:12/42/75kV;额定频率:50Hz; 功率因数:COSΦ=0.8(滞后);环境条件: 安装地点海拔高度不超过1000米; 环境温度: :40℃ 日平均不超过30℃ :-5℃; 大气条件:大气中无严重的污秽
JDZC-10,JDZC-6电压互感器 浇注式电压互感器 一、概述 JDZC-10,JDZC-6电压互感器型浇注式电压互感器为户内环氧树脂浇注式半封闭结构,适用于交流50Hz额定电压为10千伏以下的电力系统中;不但可以作电压,电能测量而且能够控制电路并为操作机构提供电源.本产品符合GBl207-97电压互感器标准。 二、主要技术参数 l负载功率因数:cosø=0.8(滞后); 2.接线图1; 3.其它技术参数见表1 ; 产品型号 额定电压比 准确级及额定输出 VA COSφ=0.8 额定绝缘水平(KV) 0.2/3 0.5/3 0.5/0.5 0.5/3P 0.5/6P JDZC-6 JDZC-10 电压互感器 6/0.1/0.22KV 30/300 50/300 50/80 50/500 50/800 7.2/32/60 10/0.1/0.22KV 30/300 50/300 50/80 50/500 50/800 ...