型电流互感器适用于220kV。50Hz电力系统中作电流、电能测量殛继电保护用。
该产品装有金属膨胀器,全密封结构,一次绕组为“U”形电容型绝缘结构,介质损耗率小,局部放电量低.二次绕组一般为4—6个绕组,级次可任意组合,可根据用户需要生产测量级准确级为0.2S级特殊用途电流互感器。
本型电流互感器为户外装置,LB7-220适用于海拔1 700m以下地区;LB7-220W1型适用于海拔1700m以下污秽地区。环境气温为-30℃- 40℃。
The current transformer for 220kV. 50Hz power systems for current and energy measurement for lightning protection.
The product is equipped with a metal expander, fully sealed structure, the primary winding as a "U" shaped capacitor-type insulating structure, dielectric loss rate is small, low partial discharge. The secondary winding is generally 4-6 windings can be any combination of levels, according to the accurate level of user needs to produce the measured level of 0.2S class of special-purpose current transformer.
The current transformer for outdoor installations LB7-220 applies to an altitude of 1 700m the following areas; LB7-220W1 apply to the dirty areas below an altitude of 1700m. Environmental temperature of -30 ° C - 40 ° C. Outline and installation size are shown in Fig.
dzsc/19/0223/19022332.jpg
FDGE9/6.6/√3-1.7-1,FDGE9/7.2/√3-1.7-1全封闭干式放电线圈概述: 本型放电线圈为环氧树脂真空浇注单相户内半封闭型产品,其适用于额定频率50Hz、额定电压10kV及以下的电力系统中。与高压并联电容器组并联连接,当电容器级与系统断开后,要在5s内将电容器组上的剩余电压降至安全电压。在正常运行时,二次绕组可以做电压指示,用户如有特殊要求时,亦可带剩余电压绕组,起到继电保护作用。技术参数:(1)产品执行标准:DL/T653-1998《电压并联电容器用放电线圈订货技术条件》;(2)负荷功率因数:COS=Φ0.8(滞后);(3)表面爬电距离:大于300mm;(4)其它技术参数见下表:dzsc/19/0225/19022581.jpg "
【详细说明】dzsc/19/0281/19028170.jpg产品说明:尺寸:65×46×46重量:≤130g触点分布形式:3Z、3H触点容量:30A/40A 250VAC 24VDC线圈额定电压:DC:6~110V AC: 6~220V线圈额定功率:DC:2.5W;AC:4.5VA绝缘电阻:≥500MΩ接触电阻:≤50mΩ抗电强度:开路触点间:1500VAC触点线圈间:2500VAC机械寿命:1×10^7次电气寿命:1×10^5次使用环境温度:-40~55℃安装方式:螺丝安装、插入式对照型号:JQX-38F