让卖家找上门
发布询价>>
您所在的位置:仪器仪表网> 电子元器件>供应LT4056-4.2/SLM6150锂离子电池充电器IC

供应LT4056-4.2/SLM6150锂离子电池充电器IC

价 格: 面议
型号/规格:LT4056-4.2/SLM6150
品牌/商标:LT

特点

  • Standalone Li-Ion Charger with Termination
  • Programmable Termination Timer
  • No Sense Resistor or Blocking Diode Required
  • Suitable for USB-Powered Charging
  • Undervoltage Charge Current Limiting
  • Preset Charge Voltage with ±0.6% Accuracy
  • Programmable Charge Current: 200mA to 700mA
  • Automatic Recharge with Shortened Charge Cycle
  • Self-Protection for Overcurrent/Overtemperature
  • 40µA Supply Current in Shutdown Mode
  • Negligible Battery Drain Current in Shutdown
  • Low Battery Charge Conditioning (Trickle Charging)
  • CHRG Status Output including AC Present
  • PCB Total Solution Area only 75mm² (700mA)
  • Low Profile (1mm) SOT-23 Package

典型应用

dzsc/18/4713/18471348.jpg

描述

The LTC®4056 is a low cost, single-cell, constant-current/ constant-voltage Li-Ion battery charger controller with a programmable termination timer. When combined with a few external components, the LTC4056 forms a very small standalone charger for single cell lithium-ion batteries.

Charge current and charge time are set externally with a single resistor and capacitor, respectively. The LTC4056 charges to a final float voltage accurate to ±0.6%. Manual shutdown is accomplished by grounding the TIMER/ SHDN pin, while removing input power automatically puts the LTC4056 into a sleep mode. Both the shutdown and sleep modes drain near zero current from the battery; the shutdown mode reduces supply current to 40µA.

The output driver is both current limited and thermally protected to prevent operating outside of safe limits. No external blocking diode or sense resistor is required. The LTC4056 also includes low battery charge conditioning (trickle charging), undervoltage charge current limiting, automatic recharge and a charge status output.

应用

  • Cellular Telephones
  • Handheld Computers
  • Digital Cameras
  • Charging Docks and Cradles
  • Low Cost and Small Size Chargers

 

深圳市福田区广辉电经营部
公司信息未核实
  • 所属城市:广东 深圳
  • [联系时请说明来自维库仪器仪表网]
  • 联系人: 陈树辉
  • 电话:0755-82534577/13076512089
  • 传真:0755-82534577
  • 手机:13686868407
  • QQ :QQ:659974144QQ:178585399
公司相关产品

供应4054锂离子电池充电器IC

信息内容:

特点 高达 800mA 的可编程充电电流 无需 MOSFET、检测电阻器或隔离二极管 用于单节锂离子电池、采用 ThinSOTTM 封装的完整线性充电器 恒定电流/恒定电压操作,并具有可在无过热危险的情况下实现充电速率化的热调 节功能* 直接从 USB 端口给单节锂离子电池充电 精度达 ± 1% 的 4.2V 预设充电电压 用于电池电量检测的充电电流监控器输出* 自动再充电 充电状态输出引脚 C/10 充电终止 停机模式下的供电电流为 25µA 2.9V 涓流充电门限 (LTC4054) 可提供无涓流充电器件版本 (LTC4054X) 软起动限制了浪涌电流 采用 5 引脚 SOT-23 封装 典型应用 dzsc/18/4713/18471349.jpg 描述 LTC®4054 是一款完整的单节锂离子电池用恒定电流/恒定电压线性充电器。其 ThinSOT 封装与较少的外部组件数目使得 LTC4054 成为便携式应用的理想选择。而且,LTC4054 是专为在 USB 电源规范内工作而设计的。 由于采用了内部 MOSFET 架构,所以不需要外部检测电阻器和隔离二极管。热反馈可对充电电流进行调节,以便在大功率操作或高环境温度条件下对芯片温度加以限制。充电电压固定于 4.2V,而充电电流可通过一个电阻器进行外部设置。当充电电流在达到...

详细内容>>

供应LTH7具有热调节功能的独立线性锂离子电池充电器IC

信息内容:

特点 高达 800mA 的可编程充电电流 无需 MOSFET、检测电阻器或隔离二极管 用于单节锂离子电池、采用 ThinSOTTM 封装的完整线性充电器 恒定电流/恒定电压操作,并具有可在无过热危险的情况下实现充电速率化的热调 节功能* 直接从 USB 端口给单节锂离子电池充电 精度达 ± 1% 的 4.2V 预设充电电压 用于电池电量检测的充电电流监控器输出* 自动再充电 充电状态输出引脚 C/10 充电终止 停机模式下的供电电流为 25µA 2.9V 涓流充电门限 (LTC4054) 可提供无涓流充电器件版本 (LTC4054X) 软起动限制了浪涌电流 采用 5 引脚 SOT-23 封装 典型应用 dzsc/18/4713/18471350.jpg 描述 LTC®4054 是一款完整的单节锂离子电池用恒定电流/恒定电压线性充电器。其 ThinSOT 封装与较少的外部组件数目使得 LTC4054 成为便携式应用的理想选择。而且,LTC4054 是专为在 USB 电源规范内工作而设计的。 由于采用了内部 MOSFET 架构,所以不需要外部检测电阻器和隔离二极管。热反馈可对充电电流进行调节,以便在大功率操作或高环境温度条件下对芯片温度加以限制。充电电压固定于 4.2V,而充电电流可通过一个电阻器进行外部设置。当充电电流在达到...

详细内容>>

相关产品