供应电源管理IC电压模式PWM 控制器6754MR
Fairchild 公司的FAN6754 是高度集成的绿色模式(Green-Mode) PWM控制器,以增强反激电源转换器的性能.为了最小化待机功耗, 绿色模式功能提供关时调制,连续降低轻负载的开关频率.工作电流1.7mA,固定PWM频率为65KHz,可线性地降低到22KHz,主要用于通用开关电源(SMPS)和包括电源适配器在内的反激式电源转换器.本文介绍FAN6754主要特性,方框图以及应用电路.
FAN6754: Highly Integrated Green-Mode PWM Controller
The highly integrated FAN6754 PWM controller provides several features to enhance the performance of flyback converters. To minimize standby power consumption, a proprietary green-mode function provides off-time modulation to continuously decrease the switching frequency under light-load conditions.
Under zero-load and very light-load conditions, FAN6754 saves PWM pulses by entering deep burst mode. This burst mode function enables the power supply to meet international power conservation requirements.
FAN6754 integrates a frequency-hopping function internally to reduce EMI emission of a power supply with minimum line filters. Built-in synchronized slope compensation is accomplished by, proprietary internal compensation for constant output power limit over universal AC input range. Also, the gate output is clamped at 13V to protect the external MOSFET from over-voltage damage.
Other protection functions include AC input brownout protection with hysteresis and VDD over-voltage protection. For over-temperature protection, an external NTC thermistor can be applied to sense the external switcher’s temperature. When VDD OVP or OTP are activated, an internal latch circuit is used to latch-off the controller. The latch mode is reset when the VDD supply is removed.
FAN6754 is available in an 8-pin SOP package.
FAN6754主要特性:
High-Voltage Startup
AC Input Brownout Protection with Hysteresis
Low Operating Current: 1.7mA
Linearly Decreasing PWM Frequency to 22KHz
Frequency Hopping to Reduce EMI Emission
Fixed PWM Frequency: 65KHz
Peak-Current-Mode Control
Cycle-by-Cycle Current Limiting
Leading-Edge Blanking (LEB)
Internal Open-Loop Protection
GATE Output Maximum Voltage Clamp: 13V
VDD Under-Voltage Lockout (UVLO)
VDD Over-Voltage Protection (OVP)
Programmable Over-Temperature Protection (OTP)
Internal Latch Circuit (OVP, OTP)
Open-Loop Protection (OLP); Restart for MR, Latch for ML
Built-in 8ms Soft-Start Function
Constant Power Limit (Full AC Input Range)
Internal OTP Sensor with Hysteresis
FAN6754应用:
General-purpose switch-mode power supplies and flyback power converters, including:
Power Adapters
dzsc/18/1622/18162249.jpg
图1.FAN6754功能方框图
dzsc/18/1622/18162249.jpg
dzsc/18/1622/18162249.jpg
概述 本系列电流互感器是参照GB1208-1997《电流互感器》以及国际电工委标准IEC-185标准设计电流互感器。该互感器根据电流大小以及标准铜排的规格设计的;因此各穿排孔的尺寸,均与标准铜排相匹配。本互感器为方孔型(除-30外),适合汇流排安装,根据使用需要可选用单排、双排、三排;也可穿越电缆。本互感器安装便捷,接线方便、可靠、安全。可供额定电压0.66KV及以下,额定频率50~60Hz交流电流中使用。 a) 测量用电流互感器是一种用于供电交流设备上,用于电气测量计量电流互感器。 b) 本公司测量用电流互感器额定二次电流标准值为: 1A、5A。 c) 本公司测量用电流互感器精度为:1级、0.5级、0.2级。 使用说明 一、 使用范围 1. 用于将大电流转变为便于测量的电流值的场合。 2. 工作电压不大于0.66KV。 3. 额定频率:50Hz—60Hz。 4. 周围气温自然变化值-5℃至+45℃。 5. 海拔高度不大于2000m。 6. 用于无严重影响互感器绝缘的气体、化学沉积物,尘埃、污垢及其它爆炸性的侵蚀性介质场所。 7. 安装场所应无雨雪侵袭,无剧烈振动。 二、 使用方法 1. 根据一次电流确定汇流母排尺寸,选择相应窗孔规格的互感器。 2. P1为一次母线穿入方向,P2...
MQ-2/MQ-2S 可燃气体检测用特点: 应用:在较宽的浓度范围内对可燃气体有良好的灵敏度 家庭用气体泄漏报警器对液化气、丙烷、氢气 的灵敏度较高 工业用可燃气体报警器长寿命、低成本 便携式气体检测器简单的驱动电路即可 MQ-2/MQ-2S气体传感器所使用的气敏材料是在清洁空气中电导率较低的二氧化锡(SnO2)。当传感器所处环境中存在可燃气体时,传感器的电导率随空气中可燃气体浓度的增加而增大。使用简单的电路即可将电导率的变化转换为与该气体浓度相对应的输出信号。 MQ-2/MQ-2S气体传感器对液化气、丙烷、氢气的灵敏度高,对天然气和其它可燃蒸汽的检测也很理想。这种传感器可检测多种可燃性气体,是一款适合多种应用的低成本传感器。图1是传感器典型的灵敏度特性曲线。图中纵坐标为传感器的电阻比(Rs/Ro),横坐标为气体浓度。 Rs 表示传感器在不同浓度气体中的电阻值 Ro 表示传感器在1000ppm 氢气中的电阻值图中所有测试都是在标准试验条件下完成的。灵敏度特性:图2是传感器典型的温度、湿度特性曲线。图中纵坐标是传感器的电阻比(Rs/Ro)。 Rs表示在含1000ppm 丙烷、不同温/湿度下传感器的电阻值 Ro表示在含1000ppm 丙烷、20℃/65%RH环境条件下传感器的电阻值温/湿...