询价
原装供应ATOS减压阀,阿托斯减压阀样本
ATOS直动式减压阀通常与双作用气动执行机构配套使用，两位是两个位置可控：
开-关，五通是有五个通道通气，其中1个与气源连接，两个与双作用气缸的外部气室的进出气口连接，
而注脂流量控制阀压力过高，
Two with the internal air chamber of the inlet and outlet,
the specific working principle can refer to the double acting
pneumatic actuator working principle in the gas (or liquid)
Two three-way solenoid valve has an inlet (access air source),
1 out of the hole (available to the target device gas source),
两位三通电磁阀具有1个进气孔(接进气气源)、
1个出气孔(提供给目标设备气源)、1个排气孔(一般安装一个，如果不怕噪音的话也可以不装
减压阀常忽略压力问题。在注脂操作时，注脂压力有规半自由浮球式蒸汽疏水阀律地呈峰谷变化。
压力过低，密封漏或安全阀失效,压力过高，
注脂口阀门制造商堵塞、密封内脂类硬化或密封圈与阀球、阀板抱死。
通常注脂压力过低时，注入的润滑脂多流入阀腔底部，一般发生在小型闸阀。
a vent (generally installed one, if not afraid of noise, then you can not install
Pressure relief valve often ignore the pressure problem.
ATOS直减压阀工作原理：ATOS直动式减压阀通常与单作用气动执行机构配套使用，两位是两个位置可控：
开-关，三通是有三个通道通气，一般情况下1个通道与气源连接，
另外两个通道1个与执行机构的进气口连接，1个与执行机构排气口连接，
seal the lipid hardening or sealing ring with the valve ball, the valve plate is locked.
Usually grease pressure is too low, the injection of
grease into the bottom of the valve cavity, generally occurs in the small gate valve.
具体的工作原理可以参照单作用气动执行机构的工作原理图。
两个与内部气室的进出气口接连，具体的工作原理可参照双作用气动执行机构工作原理 在气路(或液路)上来说，
In the grease injection operation, the pressure of the grease is controlled by the semi-free float steam trap.
Pressure is too low, seal leakage or safety valve failure, the pressure is too high,
Grease the mouth of the valve manufacturer to block,
原装供应ATOS减压阀,阿托斯减压阀样本
